99
EA(B)O-6X06 01/2018 Rev. 1 3. Disassembly and Assembly
16. Install the two roll pins of the reverse shift yoke.
6008
17. Install the main shift rail at the same time that the gear
selector, selection lever and the shift block are installed,
making the rail to pass through their holes. Fit the lower
end of the rail into the front support.
18. Install and tighten selection lever (1) and gear selector
(2) Torx screws to the specied torque. Use a T40 Torx
wrench.
NOTE: Apply Loctite 262 threadlocker onto the screw
threads. Tighten to the torque of 38-44 N.m (28-32
Lb.ft).
19. Install the shift and selection block retaining roll pin.
6004
6985
6981
Transmission Assembly
1
2
To Next Page
Loading...
