Eaton easyE4 series User Manual

Appendix
List of Figures
Figure 222: Testing the circuit diagram 456
Figure 223: Doubling the flashing frequency 456
Figure 224: boot.bmp 462
Figure 225: Storing the boot.bmp file 462
Figure 226: Screenshot of Retention section that can be found in the System
settings tab in the Project view (including sample values) 473
Figure 227: Password assignment 477
Figure 228: Password submenu 478
Figure 229: Submenu for changing the password 478
Figure 230: Assigning a program password 479
Figure 231: Offline User dialog memory card 489
Figure 232: microSD memory card drive with PROGRAM folder contains
BOOT.TXT and compiled test.prg program 491
Figure 233: Offline User dialog memory card 492
Figure 234: microSD memory card drive with PROGRAM folder contains
BOOT.TXT and compiled test.prg program 494
Figure 235: boot.bmp 500
Figure 236: Storing the boot.bmp file 500
Figure 237: How the EDP evaluates circuit diagrams and function blocks 503
Figure 238: easyE4 input assigned a switch 506
Figure 239: Delay times for evaluating an DC input signal and an activated
DEBOUNCE 507
Figure 240: Switching behavior with DEBOUNCE deactivated 508
Figure 241: Delay times for evaluating an AC input signal and an activated
DEBOUNCE 509
Figure 242: Pushbutton with bounce 510
Figure 243: Switching behavior with DEBOUNCE deactivated 510
Figure 244: NET configuration without a program 524
Figure 245: Selection of NET station 525
Figure 246: Establish Ethernet connection 533
Figure 247: Search for devices with an IP address 533
Figure 248: Saving the found device's IP profile 534
Figure 249: Selecting the easyE4 device's IP address 534
Figure 250: Establish PC connection to easyE4 device 535
Figure 251: Connection to easyE4 device established 535
608
easyE4 11/18 MN050009 EN www.eaton.com

Eaton easyE4 series Specifications

General

Brand	Eaton
Model	easyE4 series
Category	Relays
Language	English