Eaton ePDU G3 - Page 143

NOTE For LCD interface information, see “Active Alarms Menu” on page 46. For Web
interface information, see “Active Alarms” on page 107.
Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 135
l
To clear flashing LCDs and the LED:
- Press any button on the ePDU or clear the alarm using the Web interface.
l
To correct a condition:
- Define the alarm condition and resolve the condition.
l
Self-correcting conditions:
- Sometimes, the alarm automatically clears when the condition resolves. For example, if a load over
current alarm is generated, the alarm is cleared when the current drops 0.1A below the level (alarm
hysteresis).