Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 142
2 232000 ePDU Outlet switch off The specified outlet is Off.
2 232100 ePDU Outlet switch on The specified outlet is On.
3 300100 Communication module restarted The communication module has been restarted by the
user.
3 300200 Ethernet cable connected The Ethernet cable is connected.
3 300300 Ethernet cable not connected The Ethernet cable is not connected.
3 300400 Factory reset requested by <interface> A factory reset has been requested through the
specified user interface.
3 300500 Ethernet card restart requested by
<interface>
An Ethernet card restart has been requested through
the specified user interface.
3 300600 Switch to bootloader mode for upgrade by
<interface>
A Switch to bootloader mode for upgrade has been
requested through the specified user interface.
3 300700 ePDU & System Log cleared The ePDU & System Log have been cleared.
3 300800 Daisy Chain device does not answer The Daisy Chain device does not answer.
3 300900 Time changed The time was changed by the user.
3 301000 Daisy chain device connected The daisy chain device is connected.
3 301100 Daisy chain device disconnected The daisy chain device is disconnected.
3 301200 Upgrade request by user An upgrade was requested by the user.
3 301300 Sensor connected The sensor was connected.
3 301400 Sensor disconnected The sensor was disconnected.
3 301500 Send mail test by user The user sent a mail test.
3 301600 User logged in The specified user logged in by the specified protocol.
3 301700 User logged out The specified user logged out by the specified
protocol.
3 301800 User logged in FTP The specified user logged in by FTP.
3 301900 User logged out FTP The specified user logged out by FTP.
3 302000 User failed to log FTP The specified user failed to log by FTP.
3 302100 Ethernet card restart in USB mode The Ethernet card has been restarted in USB mode.
3 302200 Network settings file uploaded from USB The network settings file has been uploaded from the
USB.
3 302300 eNMC module settings file uploaded from
USB
The eNMC module settings file has been uploaded
from the USB.
3 302400 ePDU settings file uploaded from USB The ePDU settings file has been uploaded from the
USB.
Table 12. ePDU and User Alarms and Events (Continued)
Type Code
Identification and
Index Code Alarm or Event Description
To Next Page
Loading...
