Eaton ePDU G3 - Page 34

NOTE Only one ePDU in a daisy-chained group can have a network connection through the
Ethernet port. This ePDU is the Host and any connected ePDUs are Devices.
Host [0]
Device [1]
Device [1]
Device [1]
Device [2]
Device [2]
Device [3]
2 Daisy Chain Ports Connected
(No Splitter Needed)
3 Daisy Chain Ports Connected
(One Splitter Needed)
4 Daisy Chain Ports Connected
(Two Splitters Needed)
Network Connection
(Ethernet Port)
Network Connection
(Ethernet Port)
Network Connection
(Ethernet Port)
Host [0]
Host [0]
Installation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 26
Figure 25. Locating the Daisy Chain Connector