Tool Information
28
Illustration Tool Ref. Description
E010003 Input shaft bearing
cone installer
E012001 Universal puller
jaw beam and
center bolt
E012002 Puller jaws for
removing bearings
and gears
Note: Use with
E012001
E012003 Countershaft rear
bearing cone puller
E012009 Front housing
bearing cup puller
E014020 Adapter plate for
transmission stand
E017021 Shift selector bar
spring remover
E018001 Socket for
removing the cam
threaded actuator
(*) Note: This tool is used as an option for locking the transmission mainshaft, allowing transmission disassem-
bly and assembly by one mechanic only. The tool allows using transmission gear ratio as a means to help in
removing and installing the mainshaft nut.
Other complementary tools are provided to make transmission service easier to be carried out. A complete list of
these tools can be seen below, in this manual.
Illustration Tool Ref. Description
E019001 Socket for locking
mainshft nut (*)
E021001 5th/Reverse speed
linked shift block
retaining roll-pin
installer
E021002 5th/Reverse speed
linked shift block
retaining roll-pin
remover
E022002 Shift lug roll-pin
remover and
installer
E022011 Universal bearing
cup remover
E023001 Rear housing oil
seal installer
E030001 Permaglide
bushing remover
Note: Use with
E003001
To Next Page
Loading...
