Rear Section
Rear Section
47
Rear Section Disassembly
2. Place transmission with rear case facing up.
3. Shift transmission into Neutral through shift bars.
WARNING! Remove the shift lug roll pin
BEFORE removing the threaded actuator of
shifting cam.
4. Using the special tool E022002, remove the shift
lug roll pin by pushing it forward into the housing.
029
6. Remove the thirteen capscrews securing the rear
case to the intermediate housing.
7. Using a rubber or plastic hammer to break the
gasket seal, carefully hit case to detach the rear
case from the intermediate housing. Remove rear
case by pulling it upwards.
8. Remove the speedometer rotor snap ring.
046
026
030
EA029B
1. Remove the gear shift lever housing assembly
from the transmission. Refer to “Gear Shift Lever
Housing”, in this manual.
819
5. Remove the plug, spring and spherical actuator
pin of the cam threaded actuator with the special
socket E018001.
9. Remove the speedometer rotor pulling it
upwards.
043
To Next Page
Loading...
