Front Section
74
Disassembly
1. Remove the metal expansion plug near to the
5th/reverse speed yoke bar.
Note:
Refer to “Expansion Plugs” in this manual
for instructions.
639b
2. Push the interlock pin to the opposite side in
order the interlock balls drop from their bores.
3. Displace the interlock pin towards the removed
expansion plug hole and remove the pin through
the housing hole.
Assembly
1. Apply grease to interlock bores to keep the balls
in place.
2. Install three interlock balls aligned from the
3rd/4th yoke bar bore and install the smallest ball
(8.0 mm diameter) located in the 1st/2nd yoke
bar bore.
280
292
EA084
3. Install the interlock pin through the housing hole
whose expansion plug was removed before.
4. Install the interlock ball located in the 5th/reverse
yoke bar bore.
EA067
EA064
To Next Page
Loading...
