Front Section
Front Section
67
Disassembly
1. Remove the retaining roll pins and remove the
parts from the shift bars.
Note: Use the 4 mm diameter E021002 pin
punch.
Shift Yoke Bars
2. If necessary, replace the shift yoke permaglide
bushings. After installing the bushing, use a
punch to lock the bushing in the bushing bore. Be
careful not to damage neither the bushing nor the
shift yoke.
FSO107
FSO107
3. If necessary, replace the shift yoke nylon pads.
FSO107
1st/2nd and 3rd/4th Speed Yoke Bar Assembly
1. Make sure the shift block is properly positioned
regarding the notch at the yoke bar end and
install the shift block on the yoke bar.
EA110
2. Make sure the 3rd/4th speed shift yoke is
properly positioned regarding the notch at the
yoke bar end and install the shift yoke on the
yoke bar.
EA110
3. Align the shift yoke with the yoke bar matching
the roll-pin holes and install the retaining roll pin.
Using tool E001044, push the roll pin until it is
ush with yoke hub.
Note: Replace the roll pin with a new one.
4. Align the shift block with the yoke bar matching
the roll pin holes and install the retaining roll pin.
Using tool E001044, push the roll pin until it is
ush with shift block hub.
Note:
Replace the roll pin with a new one.
To Next Page
Loading...
