Front Section
Front Section
59
Front Section Disassembly
1. Disassemble the rear section (refer to “Rear
Section Disassembly”).
2. Shift transmission into Neutral through shift bars.
3. With the special socket E018001, remove the
shift positioning plug, spring and ball.
4. Remove the thirteen capscrews securing the
intermediate housing to the front housing.
5. 5. From inside the front housing, remove
capscrews securing the front housing to the
intermediate housing.
152
154
156
003
6. Remove the intermediate housing.
Note:
Use pry bars between the housing
special bosses provided to detach the
intermediate housing. If necessary,
carefully hit housing’s capscrews area with
a rubber or plastic hammer to brake the
gasket seal and detach the housing.
WARNING! Do not support pry bar on housing’s
contact surface in order to not damage the sealing
surface.
157
7. Pull the 5th/reverse yoke bar upwards and
remove it.
8. Rotate the shift selector bar counterclockwise
and remove it pulling the bar upwards.
164
165
To Next Page
Loading...
