Front Section
60
9. Remove the 1st/2nd shift yoke roll pin.
Note:
Use the 4 mm diameter roll-pin punch
E021002.
10. Hold the 1st/2nd shift yoke in its place on
synchronizer groove and pull the yoke bar
upwards. When the bar lower end rises over the
housing surface (see detail), remove the bar and
shift yoke assembly.
171
11. Simultaneously, remove from the housing the
remaining assemblies of mainshaft, countershaft,
3rd/4th bar and shift yoke and input shaft, while
grasping them all together and pulling them
upwards.
173
EA037a
EA036b
EA037B
12. Take the assemblies apart.
To Next Page
Loading...
