Front Section
Front Section
83
415
412
5th/Reverse Speed Synchronizer
The 5th/reverse speed synchronizer hub has the let-
ter “R” stamped on its body.
Synchronizer hub
Synchronizer sleeve
Key (3x)
Spring (3x)
The 5th and reverse speed synchronizer rings are
smaller than the other synchronizer rings in this
transmission.
The 5th speed synchronizer ring has not the special
EFM II coating. The reverse synchronizer ring has the
special EFM II coating.
Disassembly and Assembly
The procedure for disassembling and assembling
the 5th/reverse speed synchronizer is the same
as described above for the 3rd and 4th speed
synchronizer.
Installation
The teeth ends of the 5th/reverse speed synchronizer
sleeve have one side rounded and the other side
sharp ended. Install the 5th/reverse synchronizer
assembly with the sleeve teeth rounded end facing to
the reverse gear and the sharp end facing to the 5th
speed gear.
EA073
Synchronizer assembly
Synchronizer ring
without EFM II
coating (5th speed)
Synchronizer ring
with EFM II coating
(Reverse)
398
To Next Page
Loading...
