Eaton FSO-2105 - Input Shaft; Assembly; Disassembly

Front Section
66
Disassembly
WARNING! Do NOT use the bearing roller cage
as a pressing base.
1. Place the input shaft in the press with bearing
facing up. Use the bearing inner race as a base
by using the special support E007002.
Input Shaft
2. Press the input shaft through the bearing and
remove the bearing.
Assembly
1. Position the bearing cone on the input shaft.
2. With the synchronizer side down, place the input
shaft on a base. Be careful not to damage the
synchronizer cone.
3. Using the bearing inner race as a base, press the
bearing assembly with the appropriate tubular
tool, until the race shoulder be against the shaft
face.
WARNING! Apply force to bearing inner race.
NEVER apply force to the bearing cage.
194
EA108
EA108
EA108
EA108