Front Section
Front Section
65
Disassembly
WARNING! Do NOT use the bearing roller cage
as a pressing base.
1. Place the countershaft in the press with the front
bearing facing up. Use the bearing inner race as
a base by using the special support E007008.
Countershaft
2. Use a tubular tool and press the countershaft
through the front bearing to remove the bearing.
3. Turn the countershaft over and use the rear
bearing cone as a pressing base by using the
E007008 special device.
4. Press the countershaft through the rear bearing
and remove the bearing.
EA043
EA167
EA043
EA167
Assembly
1. Position both the front and the rear bearing cones
on the countershaft.
2. Use two tubes of the appropriate size and
diameter or use the special tool E010010 and
place the countershaft in the press, using the
inner races of those two bearings as a base.
WARNING! NEVER use the bearing roller cage
as a pressing base.
EA107
EA107
3. Press both bearings until they rest against the
shaft shoulders.
To Next Page
Loading...
