Front Section
72
Disassembly
1. Remove the metal expansion plug from housing
hole where is located the interlocking mechanism
retaining roll pin.
Note:
Refer to “Expansion Plugs” in this manual
for instructions.
EA060
2. Through the housing hole, remove the roll pin.
Note:
Use a 4 mm diameter roll-pin punch.
3. Pull the interlock pin upward and remove the
mechanism assembly.
Assembly
1. Align the roll pin hole on the interlock pin with
the corresponding hole on the housing and
then install the interlocking mechanism into the
interlock pin bore.
EA061
EA062
EA062
2. Give the spring as much as the tension you can
by winding the spring on the pin and then set its
free end in the housing hole.
3. Install a new roll pin.
Note:
Replace the roll pin by a new one and use
a 4 mm diameter roll-pin punch.
EA063
EA061
To Next Page
Loading...
