Front Section
Front Section
77
Removal
1. Place the front housing properly supported with
the countershaft bearing cup side up.
2. Use special puller E012009 tted under the
bearing cup counterbore at the cup bottom and
remove the bearing cup.
Countershaft Front Bearing Cup
Installation
1. Support properly the front housing with bearing
bore side up.
2. Prior to installing the bearing cup, carefully clean
both bearing bore and cup.
3. Use the E001039 special tool and drive the
bearing cup into the bearing bore until cup is
completely seated on the bottom.
Note:
Use with the special tool E001013.
199
296
To Next Page
Loading...
