Front Section
76
Removal
1. Remove the input shaft oil bafe and oil seal
using some sort of pry bar or use a pin punch to
push them out of their bores by hitting.
Input Shaft Oil Bafe and Oil Seal
Installation
Note:
Replace bafe and seal with new ones
whenever they are removed.
1. Coat the new seal lips with the recommended
grease.
2. Install the input shaft oil seal in its bore using the
special tool E001086 to guide the seal properly.
909
211
3. Install the input shaft oil bafe, observing its
correct mounting position.
220
281
To Next Page
Loading...
