Front Section
78
Removal
1. Place the intermediate housing properly support-
ed with the bearing cup removing side down.
2. Use special devices E001035 and E001036
along with the support E024001 and remove
mainshaft and countershaft rear bearing cups
from the bearing bores.
Mainshaft and Countershaft Rear Bearing Cups
3. Remove all existing shims from mainshaft and
countershaft bearing bores.
Installation
1. Support properly the intermediate housing with
bearing bore side up.
2. Prior to installing the bearing cup, carefully clean
both bearing bore and cup.
WARNING! Dirt between the bearing cup and
the bearing bore can lead to axial clearance (end
play) adjustment error.
3. Install the bearing cups without any shim before
adjusting the transmission end play.
WARNING! Refer to “End Play Adjustment” later
in this manual.
4. Use special devices E001016 and E001039
along with the support E024001 and install the
mainshaft and countershaft rear bearing cups,
driving the bearing cup into the bearing bore until
it is completely seated on the bottom.
EA173
EA124
EA174
To Next Page
Loading...
