Rear Section
48
13. Place transmission horizontal and install the
special socket E006004 or E006005, depending
on the input shaft spline type, onto the input
shaft. Using a suitable wrench, rotate the shaft
counterclockwise for loosening the mainshaft nut.
080
082
14. Remove the special tools.
Note:
As an option to remove the mainshaft nut,
the tool E014010 may be used to lock the
mainshaft and the tool E006006 used to
remove the nut (refer to “Tool Information”,
in this manual).
15. Remove the countershaft snap ring.
049
EA028
12. Shift transmission into 1st gear using the shift
yoke bars.
Note:
With no gear shift lever housing installed,
the gear shift lever pattern is inverted.
10. Remove the rotor retaining ball from the
mainshaft.
11. Lock mainshaft using tool E019001 (socket
for locking mainshaft nut). For this purpose,
install the special socket hexagonal hole on the
mainshaft nut as shown in the gure and rotate
the shaft until the two holes on the socket match
to the nearest two holes on the housing.
Tighten the special socket to the housing with two
housing’s capscrews.
WARNING! Be careful do not overtighten
capscrews or leave them loose in order to avoid
damage to the aluminum housing.
052
078
To Next Page
Loading...
