Front Section
80
2. Slide the keys with balls out from the
synchronizer hub slots and remove them.
Assembly
1. Install the key into the key groove in the
synchronizer hub depressing the ball. Repeat this
procedure for the three keys.
371
372
3. With the hands, t the synchronizer sleeve onto
the hub pushing the sleeve downward.
Installation
1. Install the synchronizer hub with its most
protruding side facing to the 1st speed gear.
2. Install the synchronizer sleeve with its chamfered
side facing to the same side of the most
protruding side of the synchronizer hub.
2. The center of the key must coincide with
the center of the recess in the synchronizer
sleeve teeth, at the three positions. With that
in mind, align the synchronizer sleeve with the
synchronizer hub.
376
374
3. The outer synchronizer ring must be installed with
the teeth side facing to the gear and the ring lugs
must slide into the synchronizer hub key slots.
382
448
To Next Page
Loading...
