Front Section
86
WARNING! Do not apply sealant to both housing
and retaining capscrews by now! Prior to nishing the
transmission assembly is necessary to check the end
play.
12. Install the intermediate housing on the front
housing.
Note:
If necessary, carefully hit the housing’s
capscrews area with a plastic hammer to
match the housings.
13. Install the intermediate housing retaining
capscrews. Tighten capscrews crosswise to the
recommended torque.
Note: Torque = 19-25 N.m (14-19 Lb.ft)
157
14. From inside the front housing, install capscrews
securing the front housing to the intermediate
housing. Tighten capscrews to the recommended
torque.
Torque = 19-25 N.m (14-19 Lb.ft)
652
15. Proceed to mainshaft and countershaft end
play adjustment as recommended in “End Play
Adjustment”, later in this manual.
16. After determining the shim pack thickness
necessary for adjusting both mainshaft and
countershaft end play, remove intermediate
housing.
17. Use the proper drive tool and remove the rear
bearing cups (see “Mainshaft and Countershaft
Rear Bearing Cups – Removal and Installation”).
WARNING! Be careful not to swap the
adjustment shim packs between mainshaft and
countershaft when installing them.
003
18. Install the necessary shim pack thickness to
adjust the mainshaft end play in the mainshaft
rear bearing bore and next, install the bearing
cup.
Note:
Use the proper drive tool to install
the bearing cup (see “Mainshaft and
Countershaft Rear Bearing Cups –
Removal and Installation”).
EA173
To Next Page
Loading...
