123
Front Section Disassembly
4
FSO-2405 2nd Ed. 02/07 Front Section
Input Shaft
Disassembly
WARNING! Do NOT use the bearing roller
cage as a pressing base.
1. Place the input shaft in the press with bearing
facing up. Use the bearing inner race as a base
by using the proper support.
NOTE: See “Special Tools”, Ref. E007002.
2. Press the input shaft through the bearing and
remove the bearing.
Assembly
1. Position the bearing cone on the input shaft.
2. With the syncronizer side down, place the input
shaft on a base. Be careful not to damage the
synchronizer cone.
3. Using the bearing inner race as a base, press
the bearing assembly with the proper tubular
tool, until the race shoulder be against the shaft
face.
WARNING! Apply force to bearing inner
race. NEVER apply force to the bearing
cage.
NOTE: See “Special Tools”, Ref. E010003.
FSO-2405/108
1
1
3
2
E007002
To Next Page
Loading...