122
Front Section Disassembly
4
Front Section 2nd Ed. 02/07 FSO-2405
Countershaft
Disassembly
WARNING! Do NOT use the bearing roller
cage as a pressing base.
1. Place the countershaft in the press with the
front bearing facing up. Use the bearing inner
race as a base by using the proper support.
NOTE: See “Special Tools”, Ref. E007008.
2. Use a tubular tool and press the countershaft
through the front bearing to remove the bearing.
3. Turn the countershaft over and use the 1st
speed gear teeth as a pressing base by using
the special device.
NOTE: See “Special Tools”, Ref. E007001.
4. Press the countershaft through the rear bearing
and remove the bearing.
Assembly
1. Position both the front and rear bearing cones
on the countershaft.
2. Use two tubular tools and place the
countershaft in the press, using the inner races
of those two bearings as a base.
WARNING! NEVER use the bearing roller
cage as a pressing base.
NOTE: See “Special Tools”, Ref. E001043.
3. Press both bearings until they rest against the
shaft stops.
FSO-2405/107
1
FSO-2405/167
FSO-2405/43
1 2
3
4
2
1
2
To Next Page
Loading...