Eaton Fuller FSO-2405 - Determination of End Play Adjusting Shims

150
Front Section Assembly
4
Front Section 2nd Ed. 02/07 FSO-2405
Specified end play (mm)
Minimum Maximum Remarks
Countershaft 0,010 0,080 Positive clearance
Mainshaft 0,010 0,060 Positive clearance
No
Ye s
No
Ye s
The measured value
is not a valid value.
Verify if all existing
shims were removed,
if the bearing cup is
installed properly and
if the shaft is seated
properly. Redo the
measurement.
Yes/No?
Is the measured
value greater than the
maximum specified?
Measure the clearance
Is the measured value
greater than the
minimum specified?
Calculate:
Measured value minus
maximum specified = R1
Measured value minus
minimum specified = R2
Yes/No?
Shims are not
necessary.
Use a shim pack
thickness greater than
R1 and less than R2.
End
End Play Adjustment
Determination of End Play Adjusting Shims
26. Use the following flowchart and determine the shims pack thickness to adjust the
transmission end play: