138
Front Section Disassembly
4
Front Section 2nd Ed. 02/07 FSO-2405
Countershaft Front Bearing Cup
Removal
1. Place the front housing properly supported
with the countershaft bearing bore side up.
2. Use the proper tool placed under the bearing
cup counterbore at the cup bottom and remove
the bearing cup.
NOTE: See “Special Tools”, Ref. E011001.
Installation
1. Support properly the front housing with bearing
bore side up.
2. Prior to installing the bearing cup, carefully
clean both bearing bore and cup.
3. Use the proper tool and drive the bearing cup
into the bearing bore until it is completely
seated on the bottom.
NOTE: See “Special Tools”, Ref. E001033,
E001037, E001039.
2
FSO-2405/172
FSO-2405/183
1
3
To Next Page
Loading...