136
Front Section Disassembly
4
Front Section 2nd Ed. 02/07 FSO-2405
FSO-2405/84
2
FSO-2405/67
3
FSO-2405/64
4
5
FSO-2405/83
Double Gear Shifting Interlocking System
Assembly
1. Apply grease to interlock bores to keep the
balls in place.
2. Install the three interlock balls aligned from the
3rd/4th yoke bar bore and install the smallest
ball (8,0 mm diameter) located on the 1st/2nd
yoke bar bore.
3. Install the interlock pin through the housing
hole whose expansive plug was removed
before.
4. Install the interlock ball located on the 5th/
reverse yoke bar bore.
5. Install a new expansive plug in the housing
hole.
NOTE: See “Expansive Plugs” for
instructions.
To Next Page
Loading...