6.6 Fault diagnosis
If a fault is found in the system, you can attempt to pinpoint
its cause.
Contact Eaton Service if you are unable to locate the cause
or if you are in doubt.
• If there is any likelihood that correcting the
fault will result in a hazardous situation, you are
required to take all necessary precautions to
keep such hazards to a minimum.
You will need to contact Eaton Service if work
on the primary part of the installation is
required.
• All operations must be carried out by or under
the supervision of qualified personnel.
6.6.1 What to do in the event of a fault
Always make the switchgear safe if a fault occurs.
Isolate the installation, if necessary.
Eaton Service is available for advice and repair work 24
hours a day, 7 days a week.. The address and telephone
number for reporting faults will be found on the title page of
this manual.
To Next Page
Loading...
