Eaton Magnefix MD4 - Position the Switchgear on the Frame; Fitting the Dust Cap

Magnefix MD4
991.184 G01 03
25
3.3.11 Position the switchgear on the frame
1. Unpack the switchgear.
2. Remove any switch and fuse caps, if installed.
3. Remove the switch caps and the fuse caps from the
switchgear.
NOTE
Make sure no dust or dirt can penetrate into the
switch and fuse caps.
4. Place the switchgear in the frame (a).
5. Fit the switchgear to the frame using the shafts (1) and
safety rings (2).
NOTE
Fit the safety rings to the outer surface of the
frame.
6. Move the installation to the correct location and anchor
the frame to the floor.
4, 5
3.3.12 Fitting the dust cap
1. Fit the dust cap between the side plates.
1