Eaton Magnefix MD4 - Fit the C-Section to the Front of the Frame (Systems with Protected Panel Only); Checks; Spare Panels

Magnefix MD4
26
991.184 G01 03
3.3.13 Fit the C-section to the front of the
frame (systems with Protected panel
only)
1. Fit the C-section to the front of the frame after
connecting the cables (Chapter 3.9).
2. Fit the cable support section (r) to the underside of the
C-section (p).
3. Fit the cable clamps (s) to the cable support section.
4. Secure the cables in the clamps and tighten the
clamps firmly.
1 .. 4
3.3.14 Checks
1. Check the connections made. This is to ensure a
perfect earth connection.
3.3.15 Spare panels
If the switchgear contains spare panels, fit them with
covers and unfilled cable boxes.
REMARK
The cable boxes must not be sealed airtight at the
bottom.