22. Hang a double folded nylon thread (a) over the edge of
each opening in the cable box (b), with the ends
hanging inside.
23. Now slide the cable box completely on to the cast resin
insulation.
24. Fit the protection covers (c) at the rear side and secure
them.
22 .. 24
Make sure that the clamping edge of the cable box
adequately rests on the bearing face of the
protection covers.
25. Fit the hose clamp (d) to the end of the cable box and
torque it to 5 Nm (3.7 lbf).
26. Fill the cable box with grease (see Chapter 3.7).
25
To Next Page
Loading...
