Eaton SEFELEC 5 Series - Malfunction

User manual SEFELEC 5x Series 174 v1.06
In the case of incorrect syntax the dialogue error 1 message is displayed. In the case of a
code out of context the dialogue error 2 message is displayed (a code specific to a func-
tion when we are not in this function, or a digital value outside the limits).
17.5.6. LIST OF ETHERNET COMMANDS
The syntax of the commands sent on the ETHERNET connection is consistent with the
IEEE488-2 standard (1992 revision).
Reminders of the digital formats according to the IEEE488-2 standard.
NR1 format: +/-<digit>...<digit>
NR2 format: +/-<digit>...<digit>.<digit>...<digit>
NR3 format: +/-<digit>...<digit>.<digit>...<digit>E+/-<digit>...<digit>
Note: The codes in brackets are the expanded codes that can be interpreted by the de-
vice.
17.5.7. ORDERS
The command set of the ETHERNET option SEFELEC 5x is the same as that of the
RS232 interface. It is described in detail in the RS-232C interface paragraph.
17.5.8. ERROR MESSAGE
The message: CONNECTION IMPOSSIBLE appears, there are two cases to be considered:
The device has not been identified, press on Ethernet again
You have left a communication with the device open, close the connection and press
on Ethernet again