User manual SEFELEC 5x Series 198 v1.06
Cleaning the device
Only clean the device with a soft cloth or one slightly moistened with water. For the LCD
screen use a microfibre cloth.
Calibration
We recommend annual calibration of our devices. This calibration may be advanced or de-
layed depending on the rate of use of the measurement device (ask the EATON service de-
partment for advice). The latter must be carried out by qualified personnel with the detailed
procedure and duly verified calibration means. Our service department is at your disposal to
carry out the annual calibrations at the best prices and as quickly as possible.
Maintenance
Our technicians are specially qualified for verification and scheduled maintenance of meas-
uring devices.
However, the customer’s maintenance staff will need to handle the cleaning, the dust filter
changes (depending on the models) and the clearance of the vents of the device. In dusty
environments, we recommend periodic cleaning with a vacuum cleaner inside the measuring
device (compressed air not allowed).
In workshops with cold floors or using water for washing, we recommend installing the
measurement device on a pedestal to limit condensation.
Recommendation:
That the metrological functions be checked at least once a year, by the customer or a specialist.
If this period is exceeded, we cannot guarantee the accuracy of the measurements or the correct
operation of the elements of the device.
Periodicity:
To Next Page
Loading...
Need help?
General
