| 17
17 User Manual
Using the System
Options and Display
The options and display data are as follows:
F1 : Change Message this will display the EDIT MESSAGE screen.
F2 : Check Status this will display the PRINT STATUS screen.
F3 : New Message this will display the MESSAGE HEIGHT menu.
F4 : Change Setup this will display the SETUP menu.
To the right of the message window are two arrows. Using the up and down arrow keys, the user may
scroll through the message list. As the arrow key is pressed, the next message will be displayed in
the message window, and the CURRENT MESSAGE number will change as appropriate.
Editing a Message
To edit a message, scroll until the message for editing appears on the screen and select F1: Change
Message. The EDIT MESSAGE screen will be displayed and the message can be edited as described
in the remainder of this section.
eziS :1F Press F1 until the required character set is displayed
F2: Bold On/Off Toggle Bold
on or off
epyT dleiF :3F Time
Timed Message
Sequential Number
Date
Remote
Logo
F4:Chinese Character Input Mode Press F4 will change to Chinese Chareacter Input Mode as
Key Name, QuWei(Unique Code, ( PinYing, Phonet ), when
pressing F1 to chose Chinese Character
Creating a New Message
The sequence in which a new message is created depends on the number of messages currently
stored in the printer memory.
If there are no messages stored, select F3 : New Message. The MESSAGE HEIGHT menu will be
displayed.
If there are one to four messages stored, scroll to the next available message number and select
F3 : New Message. The MESSAGE HEIGHT menu will be displayed.
If there are five messages stored (i.e. memory store full), you have to delete an existing message
before you can create a new one. Scroll to the message number that you want to replace and select
F3 : New Message. Before the previous message is deleted, the printer will request confirmation by
displaying the following on the status line:
“Press F3 to confirm deletion”
If
no key is pressed within 10 seconds and the user attempts to delete the message, the warning
will be redisplayed. Pressing [F3] will confirm the deletion and the MESSAGE HEIGHT menu will be
displayed:
EDIT MESSAGE
F1： 2FspaC HGIH 7 ：Bold Off
F3： 4FepyT dleiF ：Key-Name
VOD PRESSURE PHASE
00000
000
Jet Off 2006-03-24 14:01:38
EJ28
TEST PRINT
MESSAGE HEIGHT
VOD PRESSURE PHASE
00000
000
Jet Off 2006-03-24 14:01:38
> 7 GEN STD
7 Min STD
16 GEN STD
EJ29
To Next Page