EC-JET EC-JET500 - Listing Error Message; Changing the System Setup

30 |
User Manual
Using the System
30
Solvent Shows status of solvent level check:
OK - Solvent level is acceptable
LOW - Add one bottle of solvent
(see “Routine Maintenance”)
The ink and solvent levels should show OK. If not, they must be refilled with the correct ink or solvent.
CAUTION: Only ONE bottle of APPROVED Ink or Solvent should be added when the level is reported
LOW. If the level is still reported LOW after adding one bottle of ink or solvent, it could
be that the level sensors are faulty. In this case you should contact your local EC-JET
Distributor.
Listing Error Messages
The printer maintains a current error list. This list will display any errors which have occurred since
the printer was switched on and is a record of the errors reported on the status line of the display.
The ERROR LIST menu can be viewed by pressing [F2] from the CURRENT MESSAGE screen to
display the PRINT STATUS screen, then press [F1] to display the ERROR LIST menu.
The errors in the ERROR LIST menu will be deleted automatically
when the power is switched off,
after shutdown or when the error is cleared. (For a detailed list of the different error messages and
their meanings, see “Error Messages”).
Changing the System Setup
Many system functions can be altered to suit individual requirements; this is achieved by using the
SETUP menu:
EJ65
EDIT MESSAGE
F1： 2FspaC HGIH 7 ：Bold Off
F3： 4FepyT dleiF ：Key-Name
VOD PRESSURE PHASE
00000
000
Jet Off
2006-03-24 14:01:38
TEST
PRINT STATUS
VOD PRESSURE PHASE
00000
000
Jet Off
2006-03-24 14:01:38
F1: Error List Count :
Status :
Solvent :
Ink :
WARNING MESSAGES LIST
VOD PRESSURE PHASE
00000
000
Jet Off 2006-03-24 14:01:38
> 3.04 Solvent Low