EC-JET EC-JET500 - System Warnings; No VOD Adjustments; Jet Shut down Incomplete

| 49
49 User Manual
Warning and Fault Messages
Possible causes
- The ink or solvent tanks have been overfilled.
- A leak has developed within the ink system.
- A Luer fitting has become loose on the main filter or damper.
To cure the fault, the cause needs to be rectified and the ink tray completely cleaned and dried. Contact
your local EC-JET distributor.
System Warnings
System Warnings inform the user of problems which may affect the operation of the printer but are not
serious enough to require a shutdown.
When a System Warning occurs, a message is displayed on the screen status line for a minimum time
of approximately 3 seconds.
The internal alarm buzzer is sounded twice and the alarm relay activated twice (if enabled) using 1
second pulses.
The error will remain on display after the 3 second interval until the user presses any key, or another
error occurs, or a warning message is displayed, e.g.:
All warnings and faults are logged and may be displayed by selecting F2 : Check Status and then F1
: Error List from the Print Status screen which displays all errors that have occurred:
The following pages describe the System Warnings, together with the actions to be taken (if any).
3.00 No VOD Adjustments
This warning can occur when the jet is being started, or when the jet has been running for some time.
Possible causes
- Printhead code values are set incorrectly:
Check the Printhead and Modulation values printed on the printhead serial number label found
on the conduit, with the stored values. (see “hanging the System Setup”).
- Ink viscosity is excessively out of range:
Allow the printer to run to bring the viscosity back into range.
- There is a pressure loss in the system:
Call your local EC-JET distributor.
3.01 Jet Shut Down Incomplete
This indicates that the printer was previously switched off while the jet was running or before the printer
had completed the shutdown routine. Completion of the shutdown routine is important and must be
allowed to finish.
The warning does not stop the printer from functioning. It will be reported at every subsequent printer
start-up until a jet shutdown routine is fully completed. Press the [stop] key and wait for the message:
“Jet Stopped : You May Now Switch Off ”
1
EJ91
CURRENT MESSAGE
F1： 2FegasseM tidE ：Check Status
F3： 4FegasseM weN ：Change Setup
VOD PRESSURE PHASE
00000
000
1
Jet Off
2006-03-24 14:01:38
TEST PRINT
1
EJ91
CURRENT MESSAGE
F1： 2FegasseM tidE ：Check Status
F3： 4FegasseM weN ：Change Setup
VOD PRESSURE PHASE
00000
000
1
Jet Off
2006-03-24 14:01:38
TEST PRINT