AS9216 Installation and
Maintenance Manual
Using the Command Line Interface
(CLI)
492006-2306-013-A00 ECI Telecom Ltd. Proprietary 8-5
In addition when you attempt to exit the Configuration mode (end command or
exit command), the system prompts you to commit unapplied configuration
changes:
Uncommitted changes found, commit them (yes/no/cancel)?
[cancel]
In this case:
type yes to save the configuration changes and exit the configuration
session
type no to exit the configuration session without committing the
configuration changes
type cancel to remain in the current configuration session without exiting
or committing the configuration changes
When committing commands, the CLI validates the configuration changes and
prompts for missing configuration:
Example:
device-name(config)#router ospf interface 200.1.1.1
device-name(config-interface-200.1.1.1)#commit
Aborted: 'router ospf interface 200.1.1.1 area-id' is not
configured
device-name(config-interface-200.1.1.1)#