Ecolab Ecoplus EXN-II User Manual

6.3 Set-up
You use the ‘
Set-Up’ menu to set up the unit operated using the control PCB.
Basic settings such as dishwasher type, detergent and rinse aid products used (solid,
liquid), and the use of release signals are set in this process.
When installing a complete unit, the system is already preset. Only the
dishwasher type and release signals still need to be configured.
You can configure the following:
n Dishwasher type
Ä ‘Dishwasher type - SETUP 111’ on page 35
n Cleaner setup
Ä ‘ Detergent
- SETUP 112’ on page 35
n Rinse aid setup
Ä ‘ Rinse aid
- SETUP 113’ on page 36
n Release signal setup
Ä ‘ Release signals
- SETUP 114’ on page 36
Dishwasher type - SETUP 111
The ‘Dishwasher type setup
’ screen (111) is used to determine the type of dishwasher.
This specifies whether the Ecoplus EXN-II is used on a single-tank or multi-tank
dishwasher.
- Single-tank dishwasher
- Multi-tank dishwasher
Changing the dishwasher type resets the rinsing delay time.
Detergent - SETUP 112
The ‘Detergent Setup
’ screen (112) is used to configure the detergent used and the
dosing mode.
The following detergent must be configured for the use of the Ecoplus EXN-II:
- Liquid product via pump
Depending on the conductivity probe used, the following dosing modes can be configured:
- Conductivity with inductive measuring cell
- Conductivity with conductive measuring cell
The flow rate is set directly on the detergent pump used.
Start-up
35 MAN054003, Ver. 1-02.2024

Ecolab Ecoplus EXN-II Specifications

General

Brand	Ecolab
Model	Ecoplus EXN-II
Category	Control Unit
Language	English