Edgetech 2050-DSS User Manual

4-45
=
REQUIRED TOOLS AND HARDWARE
Tools:
• 9/16” Crescent or Adjustable
Wrench
• 9/16” Crescent, Adjustable
Wrench of Socket Wrench with
9/16” Socket
Hardware:
• 3 Cable Ties
• [2] 3/8” Hex Bolts
• [2] 3/8” Nuts
• [4] 3/8” Standard Flat Washers
• [2] Washers 3/8” Fender Flat Washers
• [2] 1-16” Split Rings
Table 4-4: 2050-DSS Tow Bridle Installation Tools and Hardware
Instructions:
1. Position the detached bridle so that both ends are outside the port and starboard mounting rails
at the same point. The default position in 7-8 mounting rail holes from the forward end of the
vehicle.
Figure 4-15: Tow Fish Bridle Mounting Bracket Positioning
2. Install both sets of bridle mounting hardware. Thread 3/8” bolts through 3/8” washers and
mounting rail. Install 3/8” nut and tighten assembly using 9/16 wrenches. Secure 1-1/16” split ring
with each hardware set.
Default
Position

Edgetech 2050-DSS Specifications

General

Brand	Edgetech
Model	2050-DSS
Category	Marine Equipment
Language	English