Edgetech 8242XS - Page 15

xv
Figure 4-28: On/Off Actuator Plug on the Clevis End .............................................................................. 4-20
Figure 4-29: The ON and OFF Positions of the On/Off Actuator Plug ...................................................... 4-20
Figure 4-30: Loosen the Retainer and Move It Out of the Way ............................................................... 4-21
Figure 4-31: Push in the On/Off Actuator ................................................................................................ 4-21
Figure 4-32: Return Retainer and Tighten ............................................................................................... 4-21
Figure 4-33: Pull the On/Off Actuator Out ............................................................................................... 4-22
Figure 5-1: The Plugged in Battery and Transducers Cables ...................................................................... 5-2
Figure 5-2: The Unplugged Battery and Transducer Cables ...................................................................... 5-3
Figure 5-3: Removing the (2) Top Nut from the (2) Titanium Bolts ........................................................... 5-4
Figure 5-4: Using a Wrench to Pry the Clevis End Cap Apart ..................................................................... 5-5
Figure 5-5: Tapping the other end of the clamp with a soft Mallet........................................................... 5-5
Figure 5-6: The Electronics Assembly Completely Removed from the Housing ........................................ 5-6
Figure 5-7: O-Rings in Clevis End Cap ......................................................................................................... 5-7
Figure 5-8: Cross Section of the Face Seal, Gland, and Back-up O-Rings ................................................... 5-8
Figure 5-9: Clamping Hardware ................................................................................................................. 5-9
Figure 5-10: The Plugged in Battery Cable and Transducer Cable ........................................................... 5-11
Figure 5-11: The Battery Pack is on the Underside of the Electronics Chassis ........................................ 5-12
Figure 5-12: Close-up view of the (4) Bracket Screws and (2) Retainer Brackets .................................... 5-12
Figure 5-13: The Transducer End O-Rings ................................................................................................ 5-15
Figure 5-14: The Release End O-Rings ..................................................................................................... 5-15
Figure 5-15: The Purge Port Plug O-Rings ................................................................................................ 5-15
Figure 5-16: Cross Section of the Face Seal, Gland, and Back-up O-Rings ............................................... 5-16
Figure 5-17: 8242XS MART Main Sub Assembly – 0002737 .................................................................... 5-18
Figure 5-18: 8242XS Release Sub Electronics Release Assembly – 0002650 .......................................... 5-20
Figure 5-19: 8242XS Acoustic Release Transducer Assembly – 0003226 ................................................ 5-22
Figure 5-20: 8242XS Release Mechanism Sub Assembly – Page 1 of 2 – 002780 ................................... 5-23
Figure 5-21: 8242XS Release Mechanism Sub Assembly – Page 2 of 2 – 002780 .................................. 5-24
Figure A-1: 8242XS Remote Release – 0018268 ........................................................................................ A-2
Figure B-1: 8242XS Tandem Kit Drawing – 0006657 ................................................................................. B-2
Figure B-2: 8242XS Tandem Short – 0017034 ........................................................................................... B-3
Figure B-3: 8242XS Tandem Long – 0018532............................................................................................ B-4