Edgetech 8242XS - Figure 4-23: the Release Link Captured by the Release Hook; Figure 4-24: Capture the End of the Hook Onto the Latch Recess

SECTION 5: MAINTENANCE 4-16
To Arm the Instrument:
1. When capturing the anchor link in the hook, be sure to support the Anchor Link and the Hook.
pivoting the latch back over the T-Shaft.
Figure 4-23: The Release Link Captured by the Release Hook
2.
Capture the end of the hook behind the latch while passing the slot in the latch down over
the T-shaft, as shown in
FIGURE 4-24.
Figure 4-24: Capture the End of The Hook onto the Latch Recess