Edgetech 8242XS - Figure 5-4: Using a Wrench to Pry the Clevis End Cap Apart; Figure 5-5: Tapping the Other End of the Clamp with a Soft Mallet

5-5
5. Place a wrench into the gap between the two parts of the Clevis End Cap to pry one side of it off,
shown in F
IGURE 5-4.
Figure 5-4: Using a Wrench to Pry the Clevis End Cap Apart
6. With a soft mallet, tap the other half of the clamp to free the End Cap.
Figure 5-5: Tapping the other end of the clamp with a soft Mallet