7.12 DHCP Cfg - DHCP Server Configure
The print server can be configured as DHCP server to
provide dynamic IP addresses assignment. The DHCP Cfg
page allows you to set:
The DHCP startup, which determine if the print
server will act as DHCP server. If this item is set
to
Auto
, the print server will detect if there is
any DHCP server on the network when it boots up.
If there is no DHCP server on the network, then
the print server will configure itself as DHCP
server; otherwise it will disable this function.
DHCP setup is used to configure TCP/IP
parameters that will be assigned to a DHCP client.
If this item is set to Auto, the print server will
determine all TCP/IP parameters automatically;
otherwise you will configure the following
parameters:
To Next Page
Loading...
