(the Node ID is printed on the rear side of the print
server)
Assign IP address: 203.66.191.12
arp –s 203.66.191.12 00-00-B4-01-01-01
ping 203.66.191.12
At the mean time, print server’s IP will “temporarily” be
set to 203.66.191.12 (will restore after reboot). Therefore,
you need to run your web browser to set a permanent IP
address (refer to section 8.3.7 for detailed IP configuration).
6.3.2 DHCP
There are many Unix systems that support DHCP
protocol, and the procedures to configure the DHCP server
database are different. This manual does not describe the
DHCP server configuration on the Unix systems. It is highly
recommended that the DHCP server should be located on the
same network as the print server.
6.3.3 BOOTP
If you have the BOOTP daemon, bootpd, running on
your UNIX system that is accessible by the print server, you
can use the BOOTP protocol to set up the IP address of the
print server. We recommend that the BOOTP server should be
located on the same subnet as the print server. If you use
Network Information Services (NIS) in your system, you may
need to rebuild the NIS map with the BOOTP services before
doing the following BOOTP configuration. To rebuild the
NIS map, please refer to your system documentation.
To Next Page
Loading...
