2. Hardware Installation
1. Unpack the print server package and check all the
items listed in section 1.3.
2. Connect the print server to the printer you want to
share on the network
For direct attach models, plug the print server
directly to the printer’s centronics port.
For palmtop/desktop models, connect the printer
to print server by the standard printer cable.
3. Connect the power adapter to the print server.
4. The print server will perform the Power-On-Self-Test
(POST) after it is powered on. The Status LED will flash 6
times to indicate that the print server is ready.
NOTE1 : MUST use the power adapter shipped with the print
server, do NOT use any other power adapter from any
sources.
NOTE2: To prevent the compatibility problem between print
server and a few printer, it is recommand that you power
on the print server before the printer.
To Next Page
Loading...
