IP address: 203.66.191.12
The entry for this print server in the /etc/bootptab file
should be:
PS010101:\
:ht=1:\
:ha=0000B4010101:\
:ip=203.66.191.12:
6.3.4 RARP
The procedure below enables the RARP daemon running
on your system to respond to a RARP request from the print
server and to assign the IP address to the print server.
1. Log in the host of RARP server as the superuser
(root).
2. Assign a name corresponding to the print server ’s IP
address. You can add this address to the /etc/hosts file, by
adding a line such as:
203.66.191.12 pserver
3. Add the Ethernet address and the host name for the
print server to the /etc/ethers file, by adding a line such as:
00:00:B4:01:01:01 pserver
Where the Ethernet address of the print server is the
Node ID located on the print server.
To Next Page
Loading...
