Edimax Print Server - Setting Print Server IP Address

6.3 Setup Print Server’s IP Address
The print server must have a unique IP address in order
to be recognized by the network.
You can set up the IP address on the various Unix
systems using any one of the following methods:
1. ARP & Ping Assignment (Recommand for Unix)
2. DHCP (Dynamic Host Configuration Protocol)
3. BOOTP (Bootstrap Protocol)
4. RARP (Reverse Address Resolution Protocol)
The print server will use the last three methods to obtain
its IP address automatically if its IP address is configured as
Auto (0.0.0.0).
6.3.1 ARP & Ping Assignment
You can use ARP and Ping commands with a web
browser to complete print server’s IP address setting.
Parameters for the commands are as follows:
arp –s <IP Address> <Ethernet ID>
ping <IP Address>
For example, a print server with the following
configuration:
Node ID: 0000B4010101