NetWare 4.x/5.x software, and for 3.x and 4.x/5.x servers to
be mixed on a network.
Your print server can operate either in bindery mode or
NDS mode. Bindery mode works with NetWare 3.x servers
and with NetWare 4.x/5.x servers using bindery emulation.
NDS mode works with NetWare 4.x/5.x servers.
NOTE : Though the print server supports both bindery
mode and NDS mode, it cannot support both at the same time.
If you are using both NetWare 3.x and 4.x/5.x servers, you
need to set up the print server to use bindery mode. If you
need to install NetWare 4.x/5.x bindery mode network
printing, please refer to the previous chapter. The installation
procedure is the same as NetWare 3.x.
5.3.1 Quick Installation Using “Install” program
The INSTALL program included on the CD-ROM can be
used to quickly set up the print server for use. It can only be
used to set up the print server as Server mode; it cannot be
used to configure the print server as Remote Printer mode. To
use this method,
1. Log in to your NetWare server as ADMIN.
2. Insert the CD-ROM and change to the appropriate
drive and directory. Ex. e:\dosutil\
3. Run the INSTALL program with “NDS” option.
E :\dosutil\install /NDS
To Next Page
Loading...
