5.2 NetWare 3.x Installation & Setup
Once your print server is connected to your Ethernet
network, you can set it up for use with your networking
software. There are two methods you can use to do this
easily:
Please note that, you need install the IPX protocol before
the following procedure,
1. On DOS environment or DOS box of Windows, use
the “
INSTALL”
quick-installation program found on the
<CD-ROM Drive>\DOSUTIL of CD-ROM included with the
print server.
2. On DOS environment or DOS box of Windows, use
the “
PSETUP”
configuration program found on the included
<CD-ROM Drive>\DOSUTIL, configure the print server to
use a particular file server. Then, use NetWare’s PCONSOLE
program to create a NetWare print server and print queue
with the appropriate names.
5.2.1 Quick Installation Using “Install” program
The
INSTALL
program included on the CD-ROM can be
used to quickly set up the print server for use on the NetWare
environment. It can only be used to set up the print server as
Printer Server mode; it cannot be used to configure the print
server as Remote Printer mode. It handles changing the print
server’s internal settings, the creation of NetWare print
server and print queue objects on the file server, and the
assignment of the print server to the queue. Unless you need
to configure the NetWare settings to conform to special
To Next Page
Loading...
