Chapter 3: Configuration and Commissioning
ModuLaser Modular Aspirating Smoke Detector Installation Manual 71
The General Settings menu
Use the General Settings menu to add a custom logo to the product display or to
restore the logo to the factory default.
Note: Custom logo files must be 320 x 240 pixel PNG files and be stored at the
path _ASPIRATION\Logo\ on a USB flash drive.
For more information on the other options in this menu, see Access level 2 user
operation and configuration on page 41.
Adding a custom logo
To add a custom logo:
1. Remove the display cover, insert a USB flash drive into the USB connector,
and replace the cover.
2. Select General Settings from the Main menu, and then select
Customize/Restore Logo.
3. Select Customize Logo.
4. Select the device that you want to view or press F1 (Go To) to search for a
device by the device address.
A list of the logos included on the USB flash drive is displayed.
5. Select the logo that you want to add, and then press Enter.
Restoring the default logo
To restore the default logo:
1. Select General Settings from the Main menu, and then select
Customize/Restore Logo.
2. Select Restore Logo.
3. Select the device that you want to view or press F1 (Go To) to search for a
device by the device address.
4. Press OK to confirm the operation.
Press exit to view the home screen. The default logo is displayed if there are no
active events.
To Next Page
Loading...
Need help?
General
