Chapter 2: Installation
12 ModuLaser Modular Aspirating Smoke Detector Installation Manual
Electrical safety
WARNING: Electrocution hazard. To avoid personal injury or death from
electrocution, remove all sources of power and allow stored energy to discharge
before installing or removing equipment.
Caution: Equipment damage hazard. This product is sensitive to electrostatic
discharge (ESD). To avoid damage, follow accepted ESD handling procedures.
Installation
Overview
To install the detection system, follow these steps:
1. Fix the backplane to the wall.
See “Installing the backplane” on page 17.
2. Connect all field wiring to the backplane.
See “Connections” on page 20.
3. Place the display or detector module (without the cover) onto the backplane.
See “Installing the display and detector modules” on page 31.
4. Install piping.
See “Connecting pipes” on page 32.
5. Place the front cover onto the display or detector module.
To Next Page
Loading...
